Taswell 50 Specifications

Specifications

Dimensions
Construction
Steering System
Deck Equipment
Tankage
Plumbing
Electrical System
Engine System
Lewmar Winches
Spar & Riggings
Sails

Dimensions

L.O.A.:	50'1"/15.26m
L.W.L.:	41'11"-7/16"/12.79m
BEAM:	15'0"/4.57m
DRAFT (FIN KEEL STD):	7'0"/2.13m (LEAD)
DRAFT (SHOAL KEEL):	6'1"/1.98m (LEAD)
DRAFT (SCHEEL KEEL):	5'6"/1.68m (LEAD)
DISPLACEMENT:	40,000 lbs / 18,182 kg
BALLAST:	11,500 lbs / 5,217 kg (LEAD)

Construction

FRP hull, hand-lay-up lamination complied with Lloyd's specifications. ABC certificate available with extra charge
The first three layers of hull, laminated with Vinylester resin
Deck and cabin side structure with end grain Balsa core
Hull constructed with foam filled longitudinal stringers on port and starboard side and reinforced by unidirectional roving tape
FRP rudder with S/S stock and reinforced by S/S frames
Bronze seacocks and hull fittings are fully bonded
Internal cast lead ballast

Steering System

FRP molded pedestal equipped with EDSON cable steering system, 38" steering wheel
Emergency tiller

Deck Equipment

316 S/S deck fittings
S/S chain plates
S/S bow pulpit with FWD access and S/S stern pulpit with center access and folding down swimming ladder
Teak cap rail, fair leads and S/S cleats
Lewmar ocean portlights in hull, Lewmar STD portlights in cabin
Six (6) S/S dorade vents with S/S protect guard
One (1) FRP shell type vent for engine room blower and stove extractor discharge.
One (1) external gas tank locker insulated from interior for two (2) 20 lbs gas tanks storage
S/S lifeline stanchions
S/S hand rail over cabintop, companion way hatch and transom
Lewmar sheet tracks and cars
Deck hatches over every cabin and salon area

Tankage

One black iron fuel tank, total capacity 113 gal
Three S/S water tanks, total capacity 141.5 gal
Two FRP holding tanks, capacity 25 gal for FWD and AFT heads

Plumbing

Hot and cold water pressure system with 12V pressure pump
110V/220V and engine heat exchange assist water heater, capacity 11 gal
One fresh water foot pump in galley
One electrical bilge pump
One manual bilge pump
Two shower sump pumps

Electrical System

BASS electrical distribution panel: DC 12V/AC 110V or 220V system STD
YANMAR engine control panel
110V or 220V shore power connector
Two 200AH batteries with FRP boxes for house
One 120AH batteries with FRP boxes for engine
Two engine room blowers

Engine System

YANMAR 4JH2-HTBE 4 cylinder diesel 75 HP
Sound insulation in engine compartment
Space for generator installation
DURAMAX propeller shaft seal
19"øD x 12"P x 3B, RH bronze propeller
1"-1/2"øD x 316 S/S propeller shaft

Lewmar Winches

44 STC X 1: main sheet
40 STC X 1: main halyard
58 STC X 2: primary sheet
48 STC X 1: primary halyard
40 STC X 2: staysail sheet
30 STC X 1: staysail halyard
16 STC X 1: main reefing (optional)

Spar & Riggings

FORESPAR mast with double spreader and boom, supplied by dealer
Running riggings supplied by dealer
Standing rigging supplied by dealer

Sails

UK Tetron working sails
Main sail with 2 reefs including sail cover. 482 ft²/45 m²
Hanks of staysail including sail bag. 241 ft²/22.43 m²
Hanks of Yankee including sail bag. 573 ft²/53.21 m²

Note: all specifications are subject to change without notice.