|
New
Yachts | Taswell 50 Raised
Salon | Specifications
SPECIFICATIONS
Dimensions
Construction
Steering System
Deck Equipment
Tankage
Plumbing
Electrical System
Engine System
Lewmar Winches
Spar & Riggings
Sails
DIMENSIONS:
| L.O.A.: |
50'1"/15.26m
|
| L.W.L.: |
41'11"-7/16"/12.79m
|
| BEAM: |
15'0"/4.57m
|
| DRAFT
(FIN KEEL STD): |
7'0"/2.13m
(LEAD)
|
| DRAFT
(SHOAL KEEL): |
6'1"/1.98m
(LEAD)
|
| DRAFT
(SCHEEL KEEL): |
5'6"/1.68m
(LEAD)
|
| DISPLACEMENT: |
40,000
lbs / 18,182 kg
|
| BALLAST: |
11,500
lbs / 5,217 kg (LEAD)
|
Back
to top
CONSTRUCTION:
- FRP
hull, hand-lay-up lamination complied with Lloyd's specifications.
ABC certificate available with extra charge
- The
first three layers of hull, laminated with Vinylester resin
- Deck
and cabin side structure with end grain Balsa core
- Hull
constructed with foam filled longitudinal stringers on port and
starboard side and reinforced by unidirectional roving tape
- FRP
rudder with S/S stock and reinforced by S/S frames
- Bronze
seacocks and hull fittings are fully bonded
- Internal
cast lead ballast
Back
to top
STEERING
SYSTEM:
- FRP
molded pedestal equipped with EDSON cable steering system, 38"
steering wheel
- Emergency
tiller
Back
to top
DECK
EQUIPMENT:
- 316
S/S deck fittings
- S/S
chain plates
- S/S
bow pulpit with FWD access and S/S stern pulpit with center access
and folding down swimming ladder
- Aluminum
toe rail, fair leads and S/S cleats
- Lewmar
ocean portlights in hull; Lewmar STD portlights at cabin side
- S/S
lifeline stanchions
- S/S
hand rail over cabintop, companion way hatch and transom
- One
(1) FRP shell type vent for engine room blower and stove extractor
discharge
- Four
(4) S/S dorade vents with S/S protect guard
- One
(1) external gas tank locker insulated from interior for two (2)
20 lbs gas tanks storage
- Lewmar
sheet tracks and cars
- Deck
hatches over every cabin and salon area
Back
to top
TANKAGE:
- Two
black iron fuel tanks in P/S engine room, total capacity 250 gal
- Three
S/S water tanks, total capacity 200 gal
- Two
FRP holding tanks, capacity 25 gal for FWD and AFT heads
Back
to top
PLUMBING:
- Hot
and cold water pressure system with 12V pressure pump
- 110V/220V
and engine heat exchange assist water heater, capacity 15 gal
- One
fresh water foot pump in galley
- One
electrical bilge pump
- One
manual bilge pump
- Two
shower sump pumps
Back
to top
ELECTRICAL
SYSTEM:
- BASS
electrical distribution panel: DC 12V/AC 110V or 220V system STD
- YANMAR
engine control panel
- 110V
or 220V shore power connector
- Two
engine room blowers
Back
to top
ENGINE
SYSTEM:
- YANMAR
4JH2-HTBE 4 cylinder diesel 110HP
- Sound
insulation in engine compartment
- Space
for generator installation
- DURAMAX
propeller shaft seal
- 23"
x 16" x 3B, RH bronze propeller
- 1"-3/4"øD
x 316 S/S propeller shaft
Back
to top
LEWMAR
WINCHES:
- 44
STC X 1: main sheet
- 58
STC X 2: primary sheet
- 40
STC X 2: staysail sheet
Back
to top
SPAR
& RIGGINGS:
- FORESPAR
mast with double spreader and boom, supplied by dealer
- Running
riggings supplied by dealer
- Standing
rigging supplied by dealer
Back
to top
SAILS:
- UK
Tetron working sails
- Main
sail with 2 reefs including sail cover. 467 ft2/43.39
m2
- Hanks
of staysail including sail bag. 215 ft2/19.97 m2
- 95%
Hanks of Yankee. 580 ft2/53.88 m2
Back
to top
Note:
all specifications are subject to change without notice.
|
